Rv Awning Motor Maintenance

By doing this the motor should start to operate and extend or retract the awning.

Rv awning motor maintenance.

I disassembled the control panel and swapped the slide out room switch it uses the same switch with the power awning switch and the fault swapped as well. Always let the awning air dry don t use heaters. Rub down the rails pulley rollers and retracting arm to make sure they are not sticking due to friction rust or dirt. Here are seven tips for regular rv awning maintenance.

I generally clean it every few months by following the procedure outlined in the owner s manual. You yourself can replace most parts of the awning apart from few things like fabric and awning arms. Tips to maintain your rv awning. Repairing the rv awning power switch.

Step 3 fix warped rails. I tried the awning using it and it worked. This told me the motor and wiring to the awning was good. If the awning is not appropriately set the chances of getting new tears and holes will increase significantly.

Locate the supply connection terminal on the motor and connect it with the battery supply wires that you will have. If that does not happen then the motor has gone bad. The manual advises using a mixture of cup bleach cup dishwashing liquid added to 5 gallons of water. Keep the water temperature less than 100 degrees fahrenheit.

This will work for both acrylic and vinyl awnings. Don t remove end caps. Inspect pull strap slide pins rv awning motor if its electric awning. Protect your rv awning from the damaging effects of uv radiation.

You re just trying to get the dirt off not deep clean the awning. You may have to rotate the motor slightly to get the gears to line up and then rotate it back in place to line up the bolt holes. Our large 21 foot dometic 9100 rv power awning is made out of vinyl and has held up very well after 4 years of full time rving. Electric rv awning operation is simple enough and easy to maintain.

Ultraviolet rays from the sun will also take their toll on your awning. There is no purpose to take them out unless you want to replace the awning. To wash your rv awning simply hose it off. There can be several reasons for that and a repair man should be able to check on that.

One way to repair a motorized awning is to simply lubricate the working parts with some machine oil.